10-Pack Ceiling Occupancy Motion Sensor, Passive Infrared Technology, High Bay Fixture Mount 360 Degree, Hard-Wired, 120-277 VAC, Commercial/Industrial Grade

works really great!

In summary: Good product, pretty good instructions, and very good price. I attached this to a small metal Junction box with 1/2 inch knock-outs, and mounted it to the ceiling of my garage. Then added the plug end of a heavy duty extension cord to bring power to the box, and installed a duplex outlet for plugging in two shop lights. The outlets turn on whenever there is motion below, and stay on for 5 minutes (the minimum setting) after I leave. When working at by bench, with my back to the sensor, it usually picks up my arm motion and stays on for as long as I am in the area. Only once in three months has it turned off while I was working, and that was resolved by simply turning around - which triggered the lights back on. My device triggers on most any motion that lies within a 45 degree cone from the ceiling. Note that Time knob only has a few different values. It is Not infinitely adjustable. However my unit was settable down to 5 minutes, which is perfect for my use. Note also that the Instructions do not say how to adjust the "Light"knob. If you know exactly what it does, put it in a review so future customers will know.

Relatively easy to install once you understand the white goes to the neutral the black to the hot wire coming in and the red goes to the hot wire going to the light. I have only 7' ceilings, so you have to be relatively close to the sensor for it to sense you which is unfortunate since the room is too large for it to stay on unless there is movement closer to the sensor.

I always like to read "other buyers reviews" and look over a PDF install instructions when provided. This really poor wiring instruction diagram stood out as confusing. Thanks for other buyer's reviews thatmade it simple. Disconnect the the black wire from "power source" and wire direct to black wire from"sensor". The " red sensor wire" is then connected it to the other black wire just disconnected coming "out of light fixture". Wiring the "white sensor wire to white neutral bundle or white wire' coming from the power source receptacle to complete the wiring job. It should be mentioned not all 3 way switchtraveler wires coming into the power sources receptacle box are the same color so hopefully yourelectrician wired a "black pigtail" to hot source to eliminate confusion when the connecting a light or other device. I spent a few hours researching the best way to handle my wife's requested for an auto on auto off light upgrade. In my case a wall switch motion sensor was out the question and this motion sensor sure made the project extremely simple. Fifteen minutes to install on my overhead florescence light. My motion sensor works just fine and I would recommend it to others.

I installed 20 of these sensors, In the span of 6 months, 5 have already died, Very bad product, I have other similar sensors that I installed 4 years ago, and none of them died,. I would not recommend this product to anyone.!!!!!!! Not even for free,.

Mostly works, but sometimes it turns off the light when I'm still there or doesn't turn on when I enter the room (passing right under it). I would say it fails to turn on about 5% of the time. I like that it is one of the few products where the timer can be set very low (15s)

I will be using my EVERElectrix to automatically turn on my lights in my garage. I love that it will automatically turn my lights off again when I leave the garage.

Love this device. With a house full of people who can NOT trun of the lights and an electric bill that is through the roof, this was the answer. I attached this to many rooms that people walk through with hands full like our pantry. It turns the light on and then shuts if off again at a predetermined time of no motion.