Z6II Z7II Screen Protector for Nikon Z 7II / Z 6II + Top [2+2Pack] 0.3mm 9H Hardness Z7 II Z6 II Tempered Glass Cover Anti-Scrach Anti-Fingerprint Anti-Bubble

Great fit on my Nikon Z6ii, successfully installed the touch screen and upper monitor glass without a problem! No bubbles, touch screen sensitivity was not affected. Clarity is great, almost invisible apart from the edges being raised. Great quality and great value for the money.

These are great! Easy install, just make sure everything is clean and dry before install. I like how it comes with screen protectors for both screen and other small screen on top of camera. Hopefully I never have to find out if it holds up!

Was a bit hesitant to opt for this product versus a slightly higher rated competing product, despite the lack of top screen protectors in the competitor’s offering. But overall, this turned out to be a fine choice!The advertised contents were all present and none of the glass protectors were damaged. The entire kit arrives in a sealed plastic “box” about the size of a cassette tape case (remember cassettes?).Years of smartphone screen protector installation have trained me to hate the process of glass protector application. I loath it. The meticulous line-up and attempts to not capture dust underneath the protector drives me nuts. However, this was WAY better of an experience than typical due to the smaller size of the protector in this use-case. It still requires some patience and care, but I managed to get a perfect application on the first attempt.I did not use the included application stickers, though, to aid in installation. The likely would have been fine, but I instead used scotch tape. I affixed a strip of tape to each of the short edges (back protector) on the top side of the glass. I then had a helper pull off the back-side film while I was holding the scotch tape and then I used the tape to navigate the protector into exactly the right spot against the camera screen. Gently set the protector onto the rear screen, checking the alignment once more. Then once I knew it was positioned well, I did a single finger swipe along the middle of the protector, horizontally, and it adhered with zero bubbling.The top protector, while much smaller than the rear, was actually slightly more difficult to position, just due to the more limited viewpoint given finger size. But ultimately it adhered quickly and perfectly with no bubbles. I used a single piece of scotch tape on the top-side of the glass to use for alignment.The only con (though I would consider it a nitpick) is that I am not entirely convinced the rear screen protector is as optically transparent as stated. It seems like it might be ever so slightly “cloudy” and reduces overall contrast a tad. But honestly, I use the EVF for composition and focusing 99% of the time and only use the rear screen at times while chimping, so it’s not a huge issue for me.Again, happy with this overall and appreciate the piece of mind it brings in protecting my camera body.

Purchased this one as an economical solution and to replace a brand that I like when it comes to filters and lenses. I really like the packaging and the amount of suppliies that are provided with the screens. They were easy to apply, fewer air bubbles (which is a constant problem with these things) and seems to be substantial enough to take the wear that the device will have to endure. I am still skeptical about the hardness and the ability to resist scratches but time will tell. Worth the investment even if it is short lived.

While these were just a tad tricky to install, they are working great and give me a resonable amount of security on my very expensive touch screen. These were a solid investment.

Perfect screen protectors fit nicely on my z6ii

It works great and is easy to install.

Wanted to protect the monitor on my new Nikon Z7II and not lose the touch-screen feature. This screen protector works great. The protector is a perfect fit and the monitor remains sensitive to the touch so that menu items can be selected with the touch of a finger. The protector was easy to install -- just followed the simple instructions and ended up with zero bubbles under the glass. Have not yet traveled with the camera so I can't comment on the protector's scratch resistance.