Newpowa Universal Solar Panel Mounting Bracket Single Arm Pole, Wall and Ground Mounts Up to 50W

Excellent product, sturdy and well constructed. I combined 4 with rails to make a 3 x 100 watt panel solar array on the radar arch/ dinghy davits on my boat. There is room for another panel if I need it. The mounts that are built for 100 watt panels seemed flimsy compared to this setup. I used aluminum extrusion from a solar supplier for the rails. They were off cuts and cost $12 each. Once everything was bolted up I could hang from the mount (I weigh about 200lbs).

Built well but a little tricky to get the screws into the panel and bracket. It works well.

Well-built, looks nice, works with any small to medium size panel. I have a 40-watt panel which is a little larger than this was designed for but works well with panel turned sideways. Does not come with hardware for mounting to pole but a couple of hose clamps are pretty cheap at the local hardware store, or maybe could use a couple of mast-mount U-bolts.

This is a nice solid way to mount panel for boat lift charger. Looks neat and is very heavy duty. Versatile enough to mount all types and can be easily drilled should you even have to. All heavy gauge aluminum should be sturdy for years to come.

Not a very good design. You can only only set it for very limited angles. I wanted to place it at the top of a fence post and angle it up to catch sunlight from the opposite side of the fence from where it's mounted, but that was nearly impossible to do without drilling new holes in the mount. Pretty disappointing, especially since it would have been quite easy for them to add the holes necessary to allow mounting at much higher angles.

incomplete for assembly, instructions online cant be printed

It is fine for what it is. A bit heavy for the size. Works

Very sturdy and strong, well made, once mounted easy to adjust for correct angle. had to drill hole in solar panel to mount to this bracket which I had purchased from the same manufacturer they could have made it fit without having to do that it was tricky so I did not damage the solar cell.