HiLetgo 20pcs WH148 Single-Joint Potentiometer 10K B10K Variable Resistors 15mm Shaft 3Pins 10K Ohm Potentiometer

Great kit. Still have a decent amount of potentiometers left. All were in spec of the resistance they are meant to be. Work great.

Work exactly as needed. High quality components. Would definitely order again when needed

I'm pretty satisfied with these. They have good range 1.1 k ohm down to 2 ohm. This one burnt up when it got over 1/2 watt of power dissipation. So don't plan to use them as a 1/2 watt resistor! The carbon filament looks to be of good quality, and even after burning part of the filament on this pot, I could still use it by switching the side my sweeper is shorted too. If you look at my photo closely, you can see the corresponding divots in the sweeper and resistive traces.

I make small circuits on open circuit boards - and these small pots are perfect for that. They are relatively accurate; smooth turning; and small enough to minimize board footprint !! Also very inexpensive

The body on these are smaller than the standard pots of old but the shafts are the same so knobs will still work. The body size really doesn't matter much and makes for more room when installing.

When first received I tested 3 pot and got zero reading. Thought about my results and retested found had meter at wrong setting. Sorry for first review!

Good thing they were inexpensive. About half of them were open and would not register any resistance at all. The others were all intermittent. I needed 2 in a pinch and they got me through that. When I finished up my project I threw them all in the trash. I was done messing with them to the point of not wanting to spend another minute of my time on them. Garbage all the way!

I had seen som comments which complained about the actuator length of 15mm. I think this is being confused with shaft length. Actuator length is the distance traveled when turning the actuator. With testing, the actuator moves 298 degrees. The actuator or shaft diameter is 6mm. The distance the actuator travels is indeed 15mm. The shaft length is also 15mm with 7.5mm from the middle to the top and the middle to the bottom. This gives 7.5mm for the nut to tighten to a given frame (less the thickness of the frame) and 7.5mm to attach a dial. The resistance is also as stated. This is as solid as any potentiometer I have used over the years. Hope this helps.

Entsprechend Preis/Leistung Verhältnis. Schnelle Lieferung.

Van perfecto.

Artikel entspricht nicht der Abbildung ! Welle ist kürzer als die in der Abbildung. Auch die Angebe von "15 mm Actuator Length " ist irreführend. Die Zeichnung mit Angebe "L" ist nicht zu finden. Leider sind die nicht zu gebrauchen und gehen leider zurück.

Todo bien y buen funcionamiento

Je m'en sers dans mon atelier en électronique. merci. Antoine