CLC Custom Leathercraft 1111 24 in. All Purpose Construction Gear Bag with 7 Outside Pockets

I have this bag and others from CLC that is custom leather crafters. Note this bag is not leather so don't be fooled by the name, but I do believe if you go to their site you will find leather stuff like tool holders or belts and maybe bags too. I purchased this bag for 3 reasons. 1. I needed a tough big bag and this is you don't see to many this big it is like 1'x1'x2' or 12"x12"x24" made of tough very durable material go to web site to see actual material. also this bag does have actual metal hardware not plastic crap. The zipper maybe plastic but big and tough. Not long ago I was doing some field carpentry for a little while and had my tools in it. Do note that when you load it down it maybe a little hard to carry because it is a BIG bag. now it has hard hat and other job work related stuff in it. But it could hold a mess of tools I would say hard hat, belt, drill and depending on belt size maybe a saw too and other tools. or several power and hand tools. 2. I own another big bag from this company when I worked on control panels and it has lot of pockets inside and some outside a pull up handle and wheels I think there are around 66 pockets somewhat grouped in different sizes for screw drivers and wrenches and different tools around the inside and a few on the out side. This other bag I own is just as tough and I have it loaded it is probable about 8-12" widex1'6" -2' long and 1'6" to 2' high. I loaded the pockets and then the middle. I will note that the inch and a half strap holder that is well mounted did come lose but like I said I had it loaded down. I probable had 60-80 lbs in it I would carry to work I didn't use a roller type tool chest that you would keep at work I carried all my tools in everyday. Thus the reason for the pull up handle and roller wheels. which I actually didn't use that much either. This bag also worked out great I still have a lot of those tools in it too. I do also know that for what ever reason CLC stopped making that one there maybe a replacement for it not sure. and 3. I also have a CLC cell phone holder attachment type bag on my belt. this thing can be clipped on with a steel clip or it has a web type of thing the clip is attached to so you can slide your belt through it or maybe suspenders through another loop going the other way. I tried the ones that were just the clip type and found I almost lost my cell phone when in a movie theater seat once from moving around in the seat the holder slide off. So I make sure that cell phone holder is attached through a belt that way it does not come off. I have never as of yet lost my cell phone. I am old enough to use readers so I carry them and a pen or two in mine. along with cell phone. it also has a outer loop and a plastic hook like thing for a key chain it is made of the same durable material as the bag I believe. Now a while back I up graded my cell phone and the new one was wider than the old, but still fit in the belt bag holster thing. It was a little tight but the sides do give a little too. I am not sure if it was my suggestion to CLC or what but before I know it they had actually up graded this to be a little wider. The new version was wide enough to fit my newer cell phone better and with a protective case around it too. I am not sure now how I discovered this maybe measurements some where. But when I ordered I was not sure what to do because both the old and newer wider version were using the same product number at the time and maybe still do. I called CLC and spoke to someone about it a nice lady checked in to it and confirmed that yes it was updated and wider. She told me to order from them instead of amazon because amazon probable still had the older ones in stock with the same number so I did and It worked out great. I did email them a copy of a picture I took of my old one with a tape on it showing the size which helped her out too. So this cell phone holder is probable made of the same tough material as the bags and has an outer loop and plastic key clip holder the inside is one big pocket in rear near the belt clip and then there are 2 pen or pencil size holders and another area a little smaller than the cell phone part that would be opposite the belt clip loop part. I found out recently you can actually put 2 pens or pencils into each of the pen slots. it does have a flap type cover with a Velcro type latch. Works great for me so far. I may carry an extra cell phone battery down the road and may need to reorganize this or look for another one not sure yet. My cell phone is a fairly nice size smart phone. . But yes this company makes some good quality bags and accessories. I plan I buying another one of these bags down the road for traveling make a great over night bag too. hope this helps.

I spent a lot of time researching to find a great work bag for my power tools etc. and this one is better than I expected, definitely worth the money and made with really strong material, I wish there was a little more padding on the bottom but with the rubber feet it’s not a big deal. 10/10

I got this bag to replace the one that came with my Porter-Cable power tool kit that I recently purchased. The one that came with the kit would not hold all of the tools and allow the bag to be closed up. The zipper broke trying to secure all of them inside. I found this bag on Amazon and it was much larger than my current one. It's very well made of heavy canvas. There are a lot of pockets on the outside as well for extra tools, which will make this super handy for toting everything you need from one job to another. The bag is almost too big for what I needed it for, but as I add to my collection, it will still allow me to store everything with room to spare. Very happy with this purchase and happy to see everything secured in one location without fear of something falling out.

Good quality. heavier material than I thought, but that's a good thing for me. I have all my cordless saws, batteries and chargers in it. 80 to 100 pounds.

I wanted a 24 inch bag with lots of volume. This is it. I’m using this to stow and carry quantity eight 24” scaffold screw jacks. 8 screw jacks DO fit well in the bag with space left over for other accessories as well as the available external pockets. Problem is now the bag weighs more than I can lift or carry. Will be getting a second bag so I can carry half the load. Nice bag, just be careful you don’t overload.