Size:Pack of 1 "Just Choose IZOKEE: Your expert for Micro-Electronics! One-Stop-Shopping with Various Electronic Modules & Components! " IZOKEE RFID Kit, RFID-RC522 RF IC Card Reader Sensor Module with S50 Smart Card and Key Rings About RC522 chip - MFRC522 is a highly integrated read and write chip which is applicable to 13.56MHz contactless communications. - It is a non-contact read and writer card chip, low voltage, low cost and small size, is a better choice for smart meters and portable handheld devices development. - MF RC522 completely integrated in all types of 13.56MHz passive contactless communication methods and protocols. - Support 14443A compatible transponder signals. The digital part handles ISO14443A framing and error detection. In addition, support fast CRYPTO1 encryption algorithms, terminology validation MIFARE products. - MFRC522 support MIFARE series of high-speed non-contact communication, two-way data transmission rate up to 424kbit/s. - As a highly integrated 13.56MHz card reader new family of chips, there are many similarities between MF RC522, MF RC500 and MF RC530, but also have many differences. Communication between it and the host SPI mode helps to reduce the connection, reduce PCB board size and cost. Item Specifications: Operating current :13-26mA/DC 3.3V Idle current :10-13mA/DC 3.3V Sleep current: <80uA Peak current: <30mA Operating Frequency: 13.56MHz Read Range: 0 ~ 35mm (mifare1 card) Size: 40mm×60mm Module interfaces SPI: Data transfer rate maximum 10Mbit/s Package Included: 1 x RFID-RC522 Module 1 x S50 Blank IC Card 1 x S50 Key Ring 1 X Straight pins 1 X Curved pins 5 X Extra Key Rings
A**E
Had a single issue - but no quible resolution
95% of the kit worked OK - the "swipe" card worked intermittently, sometime OK most of the other time not at all. Wrote to the vendor - no issues at all, received a pull pack as a replacement. I was not even asking for a full replacment just the swipe card replacement, email conversation was easy and light hearted. Overall 100% satisfied.
J**W
Works fine once you have soldered the connectors
Used to create an RFID jukebox with a raspberry pi. Works great. Come with one card and 6 tags.Cons:- The tags don’t scan through as thick a material as the cards do. (Ie mdf wood)- not pre soldered connectors like others you can by
A**W
Review
I purchased this kit for a project and was able to complete the project with minimal further purchases. The components were not fancy but as long as handled with care I had no issues. Well packaged for delivery.
J**D
great little rfid module
A great little module and easy to program on an Arduino. The RFID tags and card are a real bonus.Had the whole solution built, tested, and working in an hour.Several source online for sample code and wiring etc
A**E
Poor Range
Range promised of 35mm is far from. Range closer to 0.5mm. Also wont read through material. Did work better when using 5v but this only increased read reliability, not range
Trustpilot
2 weeks ago
3 weeks ago