Galaxy S10+ Replacement Back Glass Panel Case with Installation Manual +Pre-Installed Camera Lens +All The Adhesive +Repair Tools for Samsung Galaxy S10 Plus SM-G975 All Carriers (Prism Blue)

Easy to install as advertised

Worked just as it should. The fit, color, everything was fine. Just wished that it came with a new screen protector too. This time, I will put a better case on my phone so the back does not crack. It took me about 5 minutes to install. Instructions were easy to follow.

After prepping my phone for the back replacement, I went to apply the glue. Very disappointed. both tubes were empty or completely dry.... unusable! Had to run to the store on Father's Day to get glue.

This came with glue,everything complete, would differently buy again

So, everything was fine except the enclosed glue. It was like the super glue you find in your junk drawer that is all dried out. I cleaned my phone, peeled off the tape and clamped for a couple hours. Looks great!

It does the job but the back is not high quality you can see the difference between this and the original glass back. The glue tube when I opened it was all dry and useless. I'll see if I can update if it falls with just the adhesive tape that comes innthe backing.

Encajo perfecto. Sin problemas de instalacion. Bien empacada

I have a few problems with this glass panel. (TDLR is cracked while being in a case, moisture can still get in, and oleophobic coating? more like lipophilic coating!)1. it somehow cracked through the Spigen tough armor case it was in. could be the case's fault, but might also be the quality of the glass.2. the glass does NOT have fingerprint resistance whatsoever. even if it looks clean, it clings to anything and everything. if you pick it up once, now the oils on your hands don't simply smudge the surface, but actually add to a crusty, gross layer that must be rubbed off with plenty of pressure. this same thing also happens whenever I take my phone out of my case. it is completely full of gunk and you cant just rub it off with a cloth, you gotta aggressively rub it with a wet cloth to get it clean, then it gets just like it was before once you touch it, or it goes back in your case.3. it isn't really water resistant. I made absolutely sure that it was as sealed on as I possibly could and I was confident for a while. so confident in fact that I took it into the pool and shot underwater videos. when I got back out, the cameras were all fogged up with moisture. I blew it with an air dryer and it went away, but as soon as the phone got back to room temp, it came back. took a while to go away, so I would not trust this to maintain its water resistance.in the end, it "works". it does the bare minimum so if you have a VERY good case, you never take your phone out of your case, and you either have a waterproof case or just don't let your phone near water, this will work. but as far as the quality of the glass goes, it sucks, and based on the description, the adhesive should have been of a higher quality to keep moisture out.