Exhaust Headers 1-1/2 in. Black Paint for 1988-1995 C1500 C2500 K1500 K2500 | 1992-1995 Suburban Blazer Jimmy | 305 350 cu. in. 5.0L 5.7L V8

1993 k2500 Perfect fit, seals great, might have some issues sealing 100% to y pipe but that's as easy as a donut gasket. 5/5 stars. Did a head gasket change on my truck and these headers woke it up monumental. Worth the money, easy install, note that the back spark plugs are hard to get to now but it's worth the power gain and sound. Great welds, thick flanges. I recommend using the gaskets for your heads and not the headers as they might not seal right. I used felpros. Fits factory y pipe, the paint ain't too great heat wise but better than rusty restrictions from stock exhaust. 10/10 would recommend. Arrived early and installed easily. If you are deciding these for your sbc 350, go for it. It's a hassle but worth the effort. I also had to do a whole engine teardown on top lol.

Arrived as expected fit perfectly makes the truck run better.

Sounds good. Breathes good. Looked good for a second until the paint peeled off and blew away immediately after firing up for the first time after installation. Still a pretty solid deal.

Used them on my son's 1994 350 Chevy pickup and bolted on easily and fit great. Would highly recommend

Fits 89 OBS great, coating is not very heat resistant though, wish I would have known prior to install, will probably end up wrapping

These headers make my built Chevy 350 sound great! Also look awesome!

I don’t honestly know how to review this because I don’t know if the header was warped or if the head on my truck was warped but it took four gaskets to get one side to seal. Either way that’s was the only issue.. I do like the quality of these headers the flange is thick welds are good and they made my little 350 sound good and woke it up just a little. Pro tip remove the finish and paint with high temp paint before installing.

Amazing quality headers. Thick mounting flanges with all the hardware to install. Only issue is that the spark plugs don’t have any room to be replaced. This is for aftermarket angled heads so see what’s the factory orientation and go with that.