Illuminate Your Space with Precision! 💡
The DMX512 to 4CH 0-10V Decoder is a versatile LED dimmer that seamlessly converts DMX512 signals to 0-10V outputs. With a user-friendly interface, it supports independent brightness adjustments across four channels and offers 30 dynamic lighting modes, making it perfect for both professional and personal lighting setups.
K**R
Allows Control of High Bay LEDs Through DMX
I have two of these connected to our 12 high bay LED fixtures at our church that are dimmed via 1-10VDC control. The signal input side of this is connected to an Enttec ODE for wireless DMX control. These work great and are easy to set up. The simple instructions provided were enough for me to figure out how to wire them up and get them communicating via DMX through the Enttec ODE. This is coming from a mechanical engineer, so you know the wiring and programming must be pretty basic if I can figure it out. My only wish is that my high bays were 0-10VDC rather than 1-10VDC, but that is not the fault of this decoder. Works as advertised with no complaints with reliability or ease of setup over the past several months they have been installed. Excellent value.
C**N
Designed for buildings, not theater, default to ON after power loss.
On power blink, all the lights come on - good for buildings, bad for theater. Well made, work well, and excellent price.
R**N
Does not go to zero
It functions fine but cannot get it to zero volts, goes to .75 and does not kill the lights. Followed instructions to go to “0” “0” but no luck . Everything else is fine.
C**H
Worked great for LED house lights in church building.
I have four of these. Work very well. Easy to assign dmx channels. Wiring diagram could be better. All of them were .5-10 volts not 0-10 volts so totally off was not an option.
B**L
DMX to 10v interface
This is the second one I've purchased. They are not expensive and work great.
A**W
Perfect accepts 10v active signals
Works for dimming my fishtank lights with a 10v controller, very happy
H**P
Didn't like dimming below 15%
Like another review, it was flickering and went off below 15-20% (1.5-2v input signal.) Otherwise worked fine.
K**R
Will not go to 0 volts so lights do not turn off completelly
I have four of these installed with my church's auditorium lighting. I have found that in the 0-10 volt setting, they only dim down to about 1 volt, which means that the lights do not go completely off. With the 1-10 volt setting, they only dim down to approximately 2 volts. This is very disappointing since we now have to use the circuit breakers to shut down the lights completely. Perhaps they need a load resistor to draw additional current to bring them down to 0 volts - I have not yet tried that solution.Other than that, they have been very dependable and I love the DIN rail mounting which allows for a very compact installation.
Trustpilot
5 days ago
2 weeks ago
