110PCS Tap and Die Set, Metric Size M2-M18 Standard Threading Tool With Adjustable Handles, Accessories and Storage Case for Cutting External and Internal Threads

Doing good

I rarely need to drill/tap more than a couple of holes at a time, so instead of using my drill I often end up using my ratcheting screwdriver and some elbow grease.

This set is great I have only used it lightly but it got the job done. The only reason why I gave it 4 and not 5 stars is that the tools are fairly loose inside the casing itself I would have loved some kind of locking mechanism to keep the tools in place. Overall great buy.

This was a lifesaver when I couldn't get to the tool store. On top of that these were a good price, delivered right to me. I had an install that included bolts with baked on powder-coat paint into the threads. That coating was stripping the steel threads of the nuts I tried to "fix it" with. In the end, this set of dies saved me a potential expensive replacement part.

I needed a metric set and bought this one thinking I wouldn't use it much. Some of the taps and dies cut nicely and others don't. My 40 year old Craftsman SAE set cuts better than these. I should have spent the money for better ones. Some times the cheep tools are as good as the expensive ones for everyday users but not this time.

I needed this for the 12x1.25 die and tap. Cheaper sets didn't have that particular size. I cross-threaded a captured stud on a Toyota and needed to re-cut the threads. The die did the job easily with some Tap Magic. I also cleaned up the cross-threaded nut with the matching tap. The sizes were identical between the two. That bodes well for the other pieces in the set.Other reviews have gone over some of the shortcomings of the case. Yep, still there. That's fine since it's what's inside that matters.

I never used a tap set before but I needed only 1 tap for my project which worked perfectly. Used it to create 4 6mm threads and repaired and existing thread that had been damaged.Now that I have a full set, I'm ready to make or repair any bolt thread.

Bought 2 kits to use for cleaning threads out that have paint or dirt debris on threaded holes. Right out of the box I noticed that the sizes were barely visible and had to tilt and twist in the light to see the sizes. Then, just a trial run of the 8/32 size in a clean threaded part resulted in the tap breaking less than 5 minutes out of the box, and not being put under a load either. Low quality packaging, labeling, and performance. Once again, you get what you pay for....