Sysly IDC20 2x10 Pins Male Header Breakout Board Terminal Block Connector with Simple DIN Rail Mounting feet

Needed this to change the pinout of a data ribbon and it performed the job excellently.

I used this to wire up the output of my PLC DC Output card to a bank of 16 relays. Now I’m able to use these relays for higher voltage/current applications. This will allow my controller to be isolated from all the equipment it controls as well.

This breakout device made my project prototyping much easier. The screw connectors make attaching and removing wires a snap. It would be almost impossible to work with the 20 wide flat cable without this breakout board.

This break-out board works as advertised. However, the wire binding posts are small and only accept smaller gauge wire. The compact design prevents installing or removing ferruled wire installed on the lower block. Silkscreen of pin designators are clearly printed. Overall, the quality is good.

Connected this board to a capacitive touch led screen via a ribbon cable in prototyping stages. Would have been miserable wiring everything without this breakout board

Thi as item works and could be a good breakout boards... i purchased 8 pieces and 3 pieces has issues with pin out no 5.. there is no continuity between out soldered side and pin out connection..... these board may not be properly tested for QC issues...

Providing the mounting brackets was very useful.