Thermal Grizzly TG Putty Advance - 30 Gram - Electrically Non-Conductive Thermal Putty for GPU Modding and Thermal Pad Replacement

This stuff is amazing. I did a re-putty on my Gigabyte 5070ti Windforce to avoid the poorly-formulated stock putty from running out and leaving my components exposed more than it already had.Given the 5070ti is a mid-range card (albeit at a high-end price), I did not feel like spending more on the "Pro" putty. All I was hoping was to meet the stock performance while avoiding running out.I only needed about 15g to replace the factory locations, and used the remaining putty between my backplate and PCB along the power rails and above the 12v connector.I was quite pleased to find that this outperforms the factory "gel" by 10-15°! My memory temps are now lower than my core temps. I paired the putty with TG's Phasesheet for the core, and could not be happier with the combo.

So far my 3080 is very quite again and not making as much noise as a ps5 underload lol

The putty itself is very good. Fully non conductive, but is very sticky and hard to clean. I did not mark it down for this because you have other choices for ease of installation. The biggest issue I had is that the spatulas included were very bad and oversized, and the worst part is that the putty stuck better to the spatula than the heat sinks/chips I was trying to put it on.

Does what I need it to do. Lowered temps significantly. Easy to apply ( I suggest using gloves for small components ). Great value for the amount you receive. Would buy again in the future

Don’t know how much better this is or isn’t compared to thermal pads I had, could just as easily been the fact that the ones on this old GPU were just too dry. But this worked well with updating an old GPU with a combination of Thermal Paste, Pads and Putty. Bit expensive but hopefully this’ll last longer and give some much needed vitality to some older equipment.

it does feel of good quality but tbh if i service another laptop and need stuff for ram i will have to go with thermal pads as this stuff confuses me its not easy to apply

This stuff is phenomenal. Strong performance and makes contact a non issue. I have a bykski block that is nice but it always requires me to reopen the darn thing a hundred times before everything is right. With the putty it worked without hassle, card can be repasted in 5 minutes. Probably the first time I’ve ever got it closed up without some kind of imperfection, too.Regarding mess, it is harder to clean, but not so much that you need to seriously worry about it if you aren’t going overboard. The putty is also reusable if you handle it right.Only real issue with this product is just like other TG products it is expensive compared to other putties, but it is actually pretty competitive.

This stuff seems incredible. In combination with some PTM7950, my Acer Nitro 5 dropped from 92C to barely cracking 60C while gaming. Absolutely phenomenal difference in thermals.