19mm Momentary Switch Ring Led

Nicely made

Functions great and looks even better. I used this as a button on my motorcycle to open the gate at the end of the driveway. It even lights up at night so I can easily see it. I’m very happy with this purchase.

Good quality. Only a 2A though. Did not work for what I needed, but that was my fault for not reading.

Below I will leave my initial 1 star review, the company reached out to me and asked how they could make things right I said send me a new switch. They sent me a new one free of charge and without question. I have installed the new switch same way as the first. Perhaps I just got a bad egg, time will tell....if this second switch fails in the same way I will change my review back. If it stays 4 stars well the switch still has not failed.I purchased this switch this past July to use as a horn button in my car. Installing it was easy and worked well the 3-5 times I used it over the next few months. I then re-build my engine so the car was sitting in my garage from October to January, out of the weather battery disconnected not being used. Just now I got around to fixing the horn as it stopped functioning, figured the problem lied elsewhere but no, touching one wire to the switch to ground horn sounds. Take my multimeter leads and started probing the switch itself, OL on all configurations. I can see the switch moving and thing still looks brand new but the contacts don't close to complete the circuit.

Easy install, takes the place of any contact switch, on when you press it, off when you release it.

It works well as a replacement for the switch in my older but still nice computer case... the power switch was OK, but the actuator button broke. The hole happened to be exactly ¾", so it fit without mod. The lights match perfectly, but for it to fit I had to solder the wires rather than use the included connector. Don't forget the heat-shrink tubing, and I cut off the NC terminal. It was hitting the metal shell of the case and since the connector on the motherboard isn't polarized, I just happened to have it so the common terminal on the switch was high and the NO terminal ground. When I closed the front panel, the NC terminal was contacting the metal of the frame and it was like the button was stuck.The LED terminal is meant for 12V, but they must be using an active current limiter or something. I was worried that it wouldn't work with the 5V power LED terminal, but there is not too much difference between 5 and 12V. It's a really nice, soft blue glow that compares nicely to the HD Activity light. If you really want 12V, tap into a fan connector, but I didn't find it necessary.The switch itself has a nice snap to it, enough tactile feedback to tell when it actuates, and when I was testing the LED on my bench at work, I checked the contact resistance and it was within the noise floor on my bench.Highly recommended for this particular application.

Bought to replace a remote battery switch on the boat. As spec’s and went in easily….and worked as expected

This switch works perfectly for a project to create a garage door switch with an indicator that the door was open. The switch and LED are independent.Some documentation things to note. The LED is rated for 12V AC/DC on the package. The instructions note DC. 12V is bright so I run it with 6.5VDC. The instructions have various wiring options but all have the switch wired in with the LED. Regardless, the LED and switch are independent. The LED does have a built in resistor (that’s why the 12v rating).Light looks good when lit. Switch is smooth momentary contact. Noiseless or almost noiseless. There’s a connector that comes with and plugs into the switch that makes wiring convenient and, I suppose, eases future wall plate removal (like to service the other switches in my application). Good quality.