AUTO METER 2397 Autogage Black Console Oil/Volt/Water Gauge,2.3125 in., Black dial/Black bezel

Highly recommendedExcellent product

Good looking gauges and easy to read. Installed on 57 chevy. Great set of gauges for the price. Only draw back is the lighting is too bright for me. May try to find some lower watt bulbs that will fit.

Putting these on my 1967 Buick Special. I have similar on 1979 Chevy C10. A must have for classic crab and trucks. Classic look great functionality..

These gauges aren't really anything fancy but they do the job and being from Autometer I selected them over other brands to ensure better quality for the very important job of engine monitoring. Although just a small cost one bulb did not work and required replacing, because I did not have the bulb going out to the local auto store was an inconvenience. I chalk it up to just bad luck. I would buy these gauges again.

I normally run digital-analog gauges but was told mechanical are more accurate. I've put enough of those gauges in a bunch of my cars, so doing these were a breeze. The only thing I'm going to ding these on, in stars, is the difference between what the temp gauge tells me, and what the display for my EFI is telling me. I'm not sure which one is the accurate one, but I'm going to lean towards what the EFI controller is telling me is correct. They're about 7 degrees apart (the gauge being the higher one). Not a big deal, since I'm only concerned with the needle in the gauge going to the H peg. Easier to keep an eye on the gauge over pulling the EFI controllerout of the glove box and sifting through the data list. I also went with the copper tube (Auto Meter # 3224) for the oil pressure gauge. Works great, and am happy with it!

Big clear markings, BEST SWEEP- NEEDLE SWINGS GREATER DISTANCE PER PSI,DEGREE F. OR VOLT- the big easily visible needle swings greater distance than my old Suntune gauge set --you could barely see the needle move for 25 oil psi at idle due to closely spaced numerals and not much sweep. TEMP is responsive accurate and easier to read than old set- Starts at 100 deg F. and you can really see the temp differences clearly!(again needle sweep angle much greater--old set started at 160 so needle hardly budged once it got to 180 or 190) THESE 2 INCH DIAMETER GAUGES ARE EASY TO READ, FIT WELL IN LIMITED DASH SPACE AND YOU CAN SEE THEM AT A QUICK GLANCE. P.S. The nylon oil hose works great, last hose lasted 20 years just take your time route it logically- I like to cover with plastic wire loom cover & with a piece of fuel line hose or grommet around it at firewall, heat sources etc. Keep in mind; copper line work hardens with flexing or vibration. Good gauges, good price, Why spend your valuable time putting in crappy gauges???

I put this in my car and is shows if the motor is getting hot. It's very accurate.

It's quality. Everything works well and is accurate.